Smooth-On XTC 3D 6.4 oz Kit - High Performance 3D Print Coating

Description

Smooth-On XTC 3D
Size: 6.4 oz Kit
XTC-3D is a protective coating for smoothing and finishing 3D printed parts. Two liquids are mixed together and brushed onto any 3D print. Coating self-levels and wets out uniformly without leaving brush strokes. Working time is 10 minutes and cure time is about 4 hours (depending on mass and temperature). XTC-3D cures to a hard, impact resistant coating that can be sanded, primed and painted. Adding colors and metal effects is easy.
Features
Inexpensive to Use – 1 oz covers 100+ square inches (see coverage information below).
90% Time & Labor Savings: XTC-3D fills in 3D print striations and creates a smooth, high gloss finish. The need to post finish is almost eliminated.
Coat any 3D Print Surface - XTC-3D can be applied to both SLA and SLS prints. It works with PLA, ABS, Laywoo, Powder Printed Parts and other rigid media. It also can be used to coat EPS, EPDM and urethane foam as well as wood, plaster, fabric, cardboard and paper.
XTC-3D does not contain VOC’s, phthalates or phosphates.
Mix Ratio By Volume
2A:1B
Mix Ratio By Weight
100A:42B
Specific Gravity
1.09 g/cc
Specific Volume
25.1 cu. in./lb.
Thin Film Working Time
20 minutes
Thin Film Recoat Time
90 minutes
Tack Free Time
2 hours
Shore Hardness
80 D
Color
Clear (Slightly Yellow In Thick Sections)
Mixed Viscosity
350 cps